Chevy/Jeep spindle bolt pattern accepts outers from all open knuckle Chevy half-ton and 3/4-ton front ends. Cast from high strength ductile iron. Machined with a Bottom Up taper to match OEM Chevy 10-Bolt tie rod location.Beefed up with extra material and ribbing. Flat tops machined and drilled for high steer arms.
4th bolt hole for high steer arms increases clamping force and sheer strength. 3/8 thickness added to flat top of the knuckle for high steer tie rod to leaf spring clearance.Cast-in DUAL steering stops eliminate bent stop bolts that can cause u-joint and axle failures. Tapered tie rod holes accept factory tie rod ends. Tie rod holes can be drilled to accept 3/4 heim ends. Interchangeable with all factory and aftermarket Dana 44 and 10-Bolt components. Fully machined and ready for installation. Machined to clear CTM u-joints without removing the grease fittings. The item "DANA 44 CHEVY 10 BOLT KNUCKLE FOR CHEVY AND JEEP PREMACHINED READY TO USE" is in sale since Monday, October 15, 2018. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Suspension & Steering\Other". The seller is "greatautodeals" and is located in Bothell, Washington. This item can be shipped to United States, Canada, Philippines, Cayman islands.